Re: Re: St Kilda Transfers

IS Edit
Monday, February 18, 2002 10:33 PM

Bill,

I've never seen a tram anywhere in the world without a basic tow coupling and many trams had on-board towbars.

Melbourne's W-2s had them under the longitudinal saloon seats. They would have been quite adequate for towing on the rail unless there was some arcane rail safety regulation which I doubt in the time period we are talking about.

Bob Murphy

----- Original Message -----

From: Bill Bolton

To: [email protected]

Sent: Tuesday, February 19, 2002 12:23 AM

Subject: Re: [TramsDownUnder] Re: St Kilda Transfers

On Mon, 18 Feb 2002 18:58:19 +1100, Kevin wrote: > On the method of transfer I would go down on the low speed > towing system. With an overall height of about 11ft + for > the car and 3ft+ for the wagon they would be giving the > loading gauge a push. So we are back to the wee hours with > probably some type of steam motive power at low speeds > 15mph etc. Maybe the 1500v turned off. (a la Sydney) Two problems with conveyance on their own wheels.... the VR trams on the whole show no evidence of couplers of any sort except for the early period when they hauled trailers, and secondly due to the low "buffing" height of the trams it would have been quite difficult to arrange any form of temporary coupling to a railway vehicle or locomotive. This doesn't mean it didn't happen, but it would have been nowhere near as straight forward as in NSW. NSW had pin and bar coupling facilities on just about every tramway vehicle and steam tram motors with buffing gear/couplers at the right height to do the hauling... plus even some match trucks to match tramway and railway vehicles. BTW, in NSW tramway profile vehicles running through railway profile special work were restricted to ~4mph and even then there were often problems. > A history of Jolimont which I read recently did not have any mention > of trams but they were heavily into Petrol /Diesel electric Rail Motors. The trams were apparently maintained at Elwood and shortly after the no 3 running shed (northern most) was added circa 1917, the No 1 shed (southern most) became a workshop from the early 1920s. Cheers Bill Bill Bolton Sydney, Australia

Yahoo! Groups Sponsor

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.